Casper

iTrader: (34)

Ok so I know there are lots of pinion caddies out there for std 10th scale pinions but anyone know of a good caddy or way to store the mod 1 pinons with the larger 5mm shafts?

joelwhite

iTrader: (62)

here you are
http://www.liquidrc.com/index.php?ma...ducts_id=59334

Casper

iTrader: (34)

I figured someone had to make one. Anyone make a cheaper plastic one!

sim600

iTrader: (15)

If you don't mind ugly, just put them all on a 5mm rod - a dowel pin or cut a sprue out of a plastic parts tree or use a body post.

Casper

iTrader: (34)

Putting them all on one rod is nice and compact but makes getting the middle ones hard. I will find something. Thanks for all the suggestions guys. I like the hot-rc one.

JayL

RPM

T-BirdJunkie

iTrader: (10)

Hard? You unscrew one, take the rest off, put them back on!

ThunderbirdJunkie keeps his pinions on a long allen wrench

bob o

iTrader: (2)

I just took two brass tubes, one that fits the Paragan holder rods and then the next size up, cut both to 3/8 in long, put one inside of the other and then soldered them to the rods on the Paragon holder.
Two tubes = less than $5.00.
Bob