80LikesDurango DEX210 Thread
05-14-2012, 04:39 PM
#5963
I omit the screws that come "up" from the bottom of the upper rear trans brace so what only screws that can be reached from above need to be removed. This cuts out about 60 seconds of tear down time to pull the trans.
It's not the fastest but once you do it a few times you'll get it in and out in about 3-5 minutes.
It's not the fastest but once you do it a few times you'll get it in and out in about 3-5 minutes.
05-14-2012, 07:06 PM
#5966
@aloksatoor
Yes, please give us some feedback on those shorties
How much do those cost?
Edit:
Are these the ones?
http://www.hobbyking.com/hobbyking/s...Lipo_Pack.html
Yes, please give us some feedback on those shorties
How much do those cost?Edit:
Are these the ones?
http://www.hobbyking.com/hobbyking/s...Lipo_Pack.html
05-14-2012, 09:42 PM
#5967
05-14-2012, 09:49 PM
#5968
I omit the screws that come "up" from the bottom of the upper rear trans brace so what only screws that can be reached from above need to be removed. This cuts out about 60 seconds of tear down time to pull the trans.
It's not the fastest but once you do it a few times you'll get it in and out in about 3-5 minutes.
It's not the fastest but once you do it a few times you'll get it in and out in about 3-5 minutes.
Im partly just used to me X6 Sq, just 4 screws and its out.
@aloksatoor
Yes, please give us some feedback on those shorties How much do those cost?
Edit:
Are these the ones?
http://www.hobbyking.com/hobbyking/s...Lipo_Pack.html
Yes, please give us some feedback on those shorties
How much do those cost?Edit:
Are these the ones?
http://www.hobbyking.com/hobbyking/s...Lipo_Pack.html
Another advantage to those I think, is the ability to run the ESC down the centre, a bit more room and should give better weight balance (not that I would notice the difference).
05-15-2012, 01:11 AM
#5969
Hey durango family..I recently bought a buggy and would like to know a good setup to start with ill most likely be running a 17.5 or open mod 7.5 not sure yet... any help would be great ....also is there any set up sheets to go off of that that pro's do..lol
I need help with shock oil WT,shock location,springs,ride height,ect,ect,ect....
I need help with shock oil WT,shock location,springs,ride height,ect,ect,ect....
05-15-2012, 01:54 AM
#5970
Hey durango family..I recently bought a buggy and would like to know a good setup to start with ill most likely be running a 17.5 or open mod 7.5 not sure yet... any help would be great ....also is there any set up sheets to go off of that that pro's do..lol
I need help with shock oil WT,shock location,springs,ride height,ect,ect,ect....
I need help with shock oil WT,shock location,springs,ride height,ect,ect,ect....
http://www.petitrc.com/setup/durango...ngoDEX210.html