Durango DEX210 Thread
#5560
Another method I heard is to use a soldering iron - dont know if it works though - haven't tried it
#5562
Tech Elite
iTrader: (43)
tried to do the cpt america bump steer mod today. 2 mm between the pivot arms and chassis, 1 mm under inner ball studs and stock height for outer ball stud. I still have a bit of bump steer. Should I also do 6mm on the ball studs near wheel, the outers? Or am I doing something wrong?
For the ackerman plate using racers edge one with back hole for inner stud
For the ackerman plate using racers edge one with back hole for inner stud
#5565
Tech Regular
iTrader: (8)
Credit for bumpsteer mod goes to Cpt. America, post #3502. Page 234 http://www.rctech.net/forum/electric...hread-234.html