nitroexpress

Depends on the type of grease. There is no consistancy with grease. Is it Vaseline or wheel bearing grease?

Go with diff silicone oil so that you can have some basis for comparison with others drivers.

-R2-

iTrader: (4)

Even g/7k/g worked good at Rev. the car was into the track better than my buggy was on power, now i need to find that for my H9. Got the new HV Balistic in geared at 15 and will head back to Rev tonite to rip some laps.

Dragula426

iTrader: (4)

Congrats Cuda Dude

garrettsdad

iTrader: (4)

could someone help me with basic starting points for mmp and 4.5 hv. thanks in advance. Chris

F N CUDA

iTrader: (34)

Thanks Dragmaster!
I returned your pm sir.

phatmonk

Is this system worth a try I have a chance to pickup one of these systems cheap.Going in a Hyper 10 SC.I could allways sell the Havoc ESC and buy a MMP?

HYPERBOY

iTrader: (1)

I am running the Mamba with success, On a 5300 mah 25c, 4.5hv comboand I get about 13 min of hard runtime. I do feel the Mamaba has a very slight delay compared to others. I have fried 2 Havoks, Some people have warrantied their ESC for a GTB but said they have less runtime.

snrscion

iTrader: (21)

Slight delay? Did you set your deadband right?

phatmonk

The combo in question is a Havoc Pro ESC.Is this the model you Fried?So they run Hot?

HYPERBOY

iTrader: (1)

It seems like a very small cog in the beginning. What deadban should I run?

I have the stock setting

HYPERBOY

iTrader: (1)

Yes, those ESC get very hot, The fan helps but if you bust it in a race or practice and continue to run it....GOODBYE ESC.....

I also had one ESC that would go into thermal mode after 3 minutes of runtime.

Oatmeal Savage

Do any of you know if it's possible to lock the center diff to make the Hyper 10SC a 2wd rear drive? And if so, how?

Cheers

F N CUDA

iTrader: (34)

Hyperdude, you back now? Been a while dude, look forward to mixin it up with you again.

Now, about your esc issues...

YOU COULD FRY A TOGGLE SWITCH!

Hope you find something that can handle your heavy trigger finger!

Where you runnin next?

Tim3

iTrader: (1)

Yes, you can use silly putty, or hot glue.

Don't forget to remove the front dive shaft, and axles.


Sounds fun! GOOD LUCk

snrscion

iTrader: (21)

well that why the stock setting has a lot of dead band. Bring it to me at the track tonight.