Academy SBv1
Ok, I dug out my Academy buggies, got em all shinned up, anyone have an idea how to work out a brace to fit a hardcase lipo pack? the existing holders are just a tad too narrow and short, but without something the bat will rub against the center shaft. Ideas?
|
You may want to look into this.
http://www.diggitydesigns.com/D3_SBV2_LipoBrace.html I know that on my SBV2Pro all I had to do was flip the center brace so it was up against my IP3800 pack. |
Originally Posted by kwiksi
(Post 6351981)
You may want to look into this.
http://www.diggitydesigns.com/D3_SBV2_LipoBrace.html I know that on my SBV2Pro all I had to do was flip the center brace so it was up against my IP3800 pack. |
On my sbv2 i taped it to the strap
|
Easy fix! On the SBV1 I simply took out the battery holders and added pegs to the screws that held them in place. I used spare plastic servo mounts and pieces of a broken ball cup. Now a thick SMC 5200 lipo fits and stays tight using the factory hold-down strap. I'll try to get a pic
|
Originally Posted by RC Dad
(Post 6358646)
Easy fix! On the SBV1 I simply took out the battery holders and added pegs to the screws that held them in place. I used spare plastic servo mounts and pieces of a broken ball cup. Now a thick SMC 5200 lipo fits and stays tight using the factory hold-down strap. I'll try to get a pic
|
All times are GMT -7. It is currently 04:59 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.