Any possibilities you could machine a "universal" dogbone for Rc10B4 ?

The extra traction a universal provides would be very use full compared to a lighter CVD...

I'd like to see this too.

The universals have been a thought as well. Price is a big factor on that one though. Ideas are plentiful but we are just starting out so as soon as the funds are flowing, more products WILL follow.
Thanks for all the ideas. I am open to any and all (reasonable) suggestions. :nod:

fri. morn bump.

A bump for this guy, his product is very nice and durable. I will be running his prototype ones for the RB5 very shortly............. Stay tuned...........:nod:

These are the wide rear bones i assume ?


anyways i think also the front lazer sp/fs dogbones would be good as well. those wear out quick.

Please let me know when the T4 ones with the extra pin hole will be available.

The RB shafts will be for the mid arm conv. As for the 4wd, that is a though but we will be concentrating on 2wd buggy and truck first.

T4 shafts are next for production. The protos are out there being run. I dont want to rush things with them but it should be soon.

I know I have said it before but thanks so much for all the suggestions and support.

I will keep an eye on this thread for cva shafts for the b4 so that i can use the same axles in both b4 and b44?

Not sure if we are going to do the CVA shafts, I dont think they will be durable enough just because of their design. Not going to rule them out though.

oh really there's a new Aluminum CV shafts this is cool!!!





___________________
aluminum plate

[QUOTE=reign16;5274144]oh really there's a new Aluminum CV shafts this is cool!!!


Thanks for the compliment. The b4 shafts have been getting good reviews from everyone that has purchased them!

:nod:

Its times like this that I wish I had a B4. Anything on the drawing boards for the xxx-cr?

bump up chris has a great product here buy them up befor they r all gone