ESC Fan Protection
I am running fans on both of my two MM ESC's to help keep them running cool. The local track tends to have a layer of small rocks/stones on it and I was worried about rocks getting stuck in the fan. So after some research I found some fan guards that fit the Novak 25mm fans I was was using. They were steel, so they would keep fingers out of harms way as well. After adding the guards I noticed the gaps would still allow small rocks to pass thru so I added a fine plastic mesh (super glued to grill). The grill can be purchased at Master Carr, part #19155K89. Just be sure to attach the guard the right way so it does not hit the fan blades.
http://i142.photobucket.com/albums/r...k413/grill.jpg I had to squeeze the guard a little to clear all four screws. http://i142.photobucket.com/albums/r...413/screen.jpg Plastic mesh added. |
b
How did you attach the fan to the ESC and how did you run power to it?
|
A 4 40 screw will thread into the heat sink fins just like on the Novak GTB. To power it just add a plug and plug it into your receiver.
|
Thanks Shark. I had been looking for those covers everywhere. I ordered two today.
|
All times are GMT -7. It is currently 12:57 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.