RC10T Rebuild

Old 04-14-2003, 12:16 PM
  #1  
Tech Regular
Thread Starter
 
omalley's Avatar
 
Join Date: Dec 2002
Location: Orange City, IA
Posts: 327
Default RC10T Rebuild

i have a old school RC10T truck and was going to get it back up for a bit of fun at the track. I took the tranny apart and relubed the gears and checked for any broken gears and such. (it has been sitting for a quite a while). I got everything back together and the electronics installed. When i fire the thing up, and give the throttle, it goes like hell but when i put on the ground it doesnt move the spur gear is going but thats it. any ideahs? I still have bushing in the diff. and it did run fine back a few years ago.
omalley is offline  
Old 04-16-2003, 07:15 PM
  #2  
Tech Regular
 
xxxtracer32's Avatar
 
Join Date: Feb 2003
Location: socal
Posts: 327
Default

which way did you put the diff in. there is the bolt on one side and a nut on the other side, you need to put the bolt on the left side and the nut on the right side if im not mistaken. also did you rebuld the diff, if so did you tighten the diff enough and after you run it for one pack check the diff to make sure its tight enough.
xxxtracer32 is offline  
Old 04-18-2003, 09:59 AM
  #3  
Tech Rookie
 
Join Date: Apr 2003
Location: Forest Lake, MN
Posts: 6
Default

Your Diff is in backwards. Buy some bearings.
Conor360 is offline  
Old 04-23-2003, 03:32 PM
  #4  
Suspended
 
Join Date: Apr 2003
Posts: 403
Default

Yeah get bearings. and what electronics do you have in it?
R C king is offline  
Old 04-25-2003, 06:10 AM
  #5  
Tech Regular
Thread Starter
 
omalley's Avatar
 
Join Date: Dec 2002
Location: Orange City, IA
Posts: 327
Default

no i dont have bearings in it.. i think i have figured it out though my slipper pad is shot.. need a new one, so the search is on for that. also need to replace the dog bones... Does anyone know if you can swap them for Universals like whats in the T2?
omalley is offline  
Old 04-26-2003, 05:31 PM
  #6  
Tech Rookie
 
Deven's Avatar
 
Join Date: Apr 2003
Location: N. Syracuse, New York
Posts: 15
Default

Universals are good, but the CVD made by MIP are even better as they are servicable. Also, if you can find 64 pitch gears for the internal transmission gears, buy them!! It'll change the ratio and make your truck a bunch quicker out of corners and from dead stops.

Good luck & have fun!!!
Deven is offline  

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.