R/C Tech Forums

Go Back   R/C Tech Forums > General Forums > Electric Off-Road

Thread Tools Search this Thread
Old 04-06-2007, 09:26 PM   #1
Tech Master
Join Date: Apr 2006
Posts: 1,592
Trader Rating: 54 (100%+)
Default AMB PT - New Wires?

Hi, the wires on my AMB PT came off flush at the case. Is there any way to repair?
jsmax is offline   Reply With Quote
Old 04-06-2007, 09:33 PM   #2
Tech Elite
Join Date: Oct 2004
Location: Michigan
Posts: 3,318
Trader Rating: 28 (100%+)

Mine did that too. I used a sharp hobby knife to cut alot of the bottom off the case. Then the wires and board are covered in a tough epoxy or something which you very carefully have to cut and peel enough to expose the wires. Bare the wires and solder the wires back on with not to hot of an iron using a pencil tip. I covered everything back up in shoo goo, plus some of the wire leads a bit away from the case so hopefully it doesn't happen again.

Have to be very careful and patient, it was almost not do-able.
Team Associated & CRC
Trackstar & Hobbywing esc's
Spektrum radios, GensAce batts, turnigy servos.
Keeping racing fun and affordable with my 8y.o. twins :)
The best track I've raced is the one in my backyard!
jbrow1 is offline   Reply With Quote

Similar Threads
Thread Thread Starter Forum Replies Last Post
Replacing wires on LRP v7.1? SammyZ Radio and Electronics 2 08-25-2008 06:56 PM
servo wires? spiderman-49 Rookie Zone 5 11-01-2006 04:21 PM
Wires!!! Tpg racer Electric On-Road 19 06-18-2006 06:21 AM
Soldering ESC wires Michael Barch Electric On-Road 4 03-03-2006 12:45 PM
REciever wires HELP Got Xray? Rookie Zone 6 02-03-2006 02:05 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off

All times are GMT -7. It is currently 08:05 PM.

Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net