JConcepts Thread
#2688
Hey guys, is there any word on the super soft goosebumps? I need to get some more, I see plenty of fronts around but I been having trouble finding rears.
#2689
#2692
There should be two small dimples indicating where to drill the holes for the screws. Typically the screws are run from the topside of the body and the nuts are placed underneath. Using a strip of servo tap between the spoiler and the body is a good idea as well, so its better supported.
#2696
1/8th Electric
Andy-
Losi eight E 1.0 running at FTR, CRCRC, Leisure Hours. Been running Pink Tapers and they're pushing. Thinking of getting gold sevens? Do they make Gold Barcodes for 1/8th yet?
Any other ideas or combinations?
Losi eight E 1.0 running at FTR, CRCRC, Leisure Hours. Been running Pink Tapers and they're pushing. Thinking of getting gold sevens? Do they make Gold Barcodes for 1/8th yet?
Any other ideas or combinations?
#2698
Tech Regular
Hi guys, Andy, I need some advice on foam trimming. I just picked up a new set of 2.2 Goosebumps front and rear (man the rears are hard to get a hold of...). I have very little experience trimming foams since just recently got back into the hobby and in the old days there were no foams...
So basically I have no problems trimming the inside edge for fitting to the rim. But what I was wondering is about trimming the outside edge to fit the natural curve of the tire?
Do you guys do this to your goosebumps? Or do you leave it square. I'm wondering what this will change on the tire itself.
Any help/advice with this would be greatly appreciated.
Cheers!
CODMAN
So basically I have no problems trimming the inside edge for fitting to the rim. But what I was wondering is about trimming the outside edge to fit the natural curve of the tire?
Do you guys do this to your goosebumps? Or do you leave it square. I'm wondering what this will change on the tire itself.
Any help/advice with this would be greatly appreciated.
Cheers!
CODMAN
#2699
Hi guys, Andy, I need some advice on foam trimming. I just picked up a new set of 2.2 Goosebumps front and rear (man the rears are hard to get a hold of...). I have very little experience trimming foams since just recently got back into the hobby and in the old days there were no foams...
So basically I have no problems trimming the inside edge for fitting to the rim. But what I was wondering is about trimming the outside edge to fit the natural curve of the tire?
Do you guys do this to your goosebumps? Or do you leave it square. I'm wondering what this will change on the tire itself.
Any help/advice with this would be greatly appreciated.
Cheers!
CODMAN
So basically I have no problems trimming the inside edge for fitting to the rim. But what I was wondering is about trimming the outside edge to fit the natural curve of the tire?
Do you guys do this to your goosebumps? Or do you leave it square. I'm wondering what this will change on the tire itself.
Any help/advice with this would be greatly appreciated.
Cheers!
CODMAN
#2700
Tech Regular
Thanks so much for the advice Andy! It's greatly appreciated, as are the great quality products from JConcepts!
CODMAN
CODMAN