387LikesJConcepts Thread
09-25-2015, 07:54 PM
#8551
PW, Any clamping hexes (front and rear) for the SC5M soon? Especially in black!
09-26-2015, 11:45 AM
#8553
I was wondering if anyone has tried the rips in the black compound. They are out of green like I use on the rear of the car and was thinking the black or blue. Was thinking of grabbing the golds for indoor clay if they were any good just to try.
Also how are their dirt-tech inserts? I want to try closed foam inserts this time since the open cell foams are breaking down quick
Also how are their dirt-tech inserts? I want to try closed foam inserts this time since the open cell foams are breaking down quick
09-28-2015, 10:48 AM
#8554
Are the foams for the 2wd front smoothies a little undersized? When I glues up my tires, the foams do not seem to fill the tire very well..
.
I was wondering if anyone has tried the rips in the black compound. They are out of green like I use on the rear of the car and was thinking the black or blue. Was thinking of grabbing the golds for indoor clay if they were any good just to try.
Also how are their dirt-tech inserts? I want to try closed foam inserts this time since the open cell foams are breaking down quick
Also how are their dirt-tech inserts? I want to try closed foam inserts this time since the open cell foams are breaking down quick
09-28-2015, 03:47 PM
#8555
problem corrected no fault of the product..
Last edited by one8updragracer; 10-09-2015 at 01:13 PM.
09-29-2015, 04:06 AM
#8557
Tech Initiate
I'm thinking the Same try get the nuts that have the serrated finish and nylon liner
Oh and keep a eye on the serrated edge they wear out
Oh and keep a eye on the serrated edge they wear out
09-29-2015, 06:11 AM
#8558
Has anyone had problems with the buggy wheels not holding the hex area tight enough.
Tried some double dees pre mounts indoor last week, tires worked great did exactly what I expected but when I went to take them off one of them was slipping. I had to run a screwdriver through the outdrive to hold the axle so I could get the wheel nut off.
Running A tekno with the closed end wheel nuts. I noticed there is definitely less "meat" in the wheel hex area compared to my AKA and Proline wheels I normally run.
Tried some double dees pre mounts indoor last week, tires worked great did exactly what I expected but when I went to take them off one of them was slipping. I had to run a screwdriver through the outdrive to hold the axle so I could get the wheel nut off.
Running A tekno with the closed end wheel nuts. I noticed there is definitely less "meat" in the wheel hex area compared to my AKA and Proline wheels I normally run.
Like you have alluded to, sounds like the close-ended wheel nuts are not allowing the wheel nut to fully engage into the wheel. Our more current wheels shouldn't have this issue and I would recommend using an open-ended wheel nut for those older wheels.
09-30-2015, 06:39 AM
#8559
PW, is it possible to do a run of 1/10th stadium Dirt Webs in black compound? I would really appreciate it.
09-30-2015, 07:11 AM
#8560
10-05-2015, 01:10 PM
#8561
Keep up to date with JConcepts at the 2015 IFMAR Worlds where new products are being covered daily - Click Here
10-06-2015, 06:40 AM
#8563
10-06-2015, 07:44 AM
#8564
Tech Fanatic
Keep up to date with JConcepts at the 2015 IFMAR Worlds where new products are being covered daily - Click Here
