JConcepts Thread
#6032
Just to clarify JC has Green (being super soft) and Gold (being clay compound)
#6034
Is the sct goosebump available with a medium or soft insert? Part number?
How soon til the Escape body for the SC10B is released and the Rip tires and narrow Hazard wheels? My son is getting my XXX-SCB and I need a new short course buggy!
Will the front and rear CVDs from the BJ4W fit the B44.2?
Has anyone heard if there will be an updated b4.2 finnisher body? I'm in need of a new body for my b4.19999 but if there is an updated finnisher id like to wait. I also want to get the t4.2 finnisher as well.
Will the new Radio bag (#2204 for the Futaba 4pk) accommodate the transmitter with the drop wheel installed?
It makes the radio wider, and the case may not close. I'm curious if you guys have tried it that way during development.
It makes the radio wider, and the case may not close. I'm curious if you guys have tried it that way during development.
there has been a few people at my local track that are getting miss marked tires. I got a pair of super soft barcodes for the front and they are clay compound... not happy about that....
#6036
hhhmmmmmm....... where did you see a pic of the new body?
#6037
Tech Elite
iTrader: (110)
I just painted one for Jconcepts Team Driver Daimon Borkowicz.
Her it is.
http://www.jconcepts.net/store/index...roducts_id=648
Here is the one I painted
Her it is.
http://www.jconcepts.net/store/index...roducts_id=648
Here is the one I painted
#6039
Any ETA on the steering rack upgrade for the B44? Will it be compatible with the .1 and.2 versions ?
MOmo
MOmo
#6040
Any ETA on the steering rack upgrade for the B44? Will it be compatible with the .1 and.2 versions ?
#6041
Tech Master
iTrader: (4)
Going to be doing any redesign on the hexhubs? 2 of them have stripped out because the screw is not long enough. One suggestion would be to use the next size up in screw size and slightly longer. I only hand tighten them because they strip so easy and then they get stuck in the wheel because i didnt tighten them enough..... just a thought
#6042
If you use a 2mm x 6mm screw rather than the 2mm x 4mm screw that is provided, it grips all the way through the hex and can be tightened down more
#6043
Going to be doing any redesign on the hexhubs? 2 of them have stripped out because the screw is not long enough. One suggestion would be to use the next size up in screw size and slightly longer. I only hand tighten them because they strip so easy and then they get stuck in the wheel because i didnt tighten them enough..... just a thought
Please contacted us directly for warranty [email protected]
#6044
R/C Tech Elite Member
iTrader: (112)
I just painted one for Jconcepts Team Driver Daimon Borkowicz.
Her it is.
http://www.jconcepts.net/store/index...roducts_id=648
Here is the one I painted
Her it is.
http://www.jconcepts.net/store/index...roducts_id=648
Here is the one I painted