JConcepts Thread
#5222
Does the Monroe Battery strap for the SC10 have more clearance for the bullet battery terminals if running a shorty pack all the way to the front?
(which you can not do with the std FT sc10 battery strap as it totally covers the battery terminals)
(which you can not do with the std FT sc10 battery strap as it totally covers the battery terminals)
#5223
With 1/8 Barcodes, which side goes to the outside, the zigzag or the wishbone style???
#5224
I dont have a Monroe, but based on this pic, It's hard to tell... They are doing it with a standard pack, but a shorty pack all the way up? I doubt it.
#5226
Any news on the anti-roll setup for the SC10 yet?
#5227
Thanks MaplestreetRC , yeah looks like it could be a close fit, Intellect lipos look as tho the terminals are a tad out wider on the pack also so i might have to buy a monroe and just see..... (don't worry I know CF is conductive )
Aslo does anyone know with the JC bodys for Short Course trucks what is better or newer "X-flow" design or "Hi-Flow" ?
Aslo does anyone know with the JC bodys for Short Course trucks what is better or newer "X-flow" design or "Hi-Flow" ?
Last edited by RCJesus; 07-30-2012 at 11:47 PM.
#5228
any chance of a flat spot on the closed cell inserts of my Subcultures to re-elevate, or should I dump them? the outer sidewall of one of the inserts is also assymetrical, what to expect?
#5229
#5230
I'm not sure personally, but look for SCT permounts or pictures of SCT tires mounted (I say this because the SCT ones will mount only one way). Just a thought
#5231
#5232
How would the SCT ones be reversible? One side of the bead is 2.2" and the other is 3.0", therefore impossible to reverse them
#5233
Hey Paul, Has any one trued cutting some 3d's for buggy fronts? Just curious if it would be better then the dd's cut.
Any news on the anti-roll setup for the SC10 yet?
Aslo does anyone know with the JC bodys for Short Course trucks what is better or newer "X-flow" design or "Hi-Flow" ?
any chance of a flat spot on the closed cell inserts of my Subcultures to re-elevate, or should I dump them? the outer sidewall of one of the inserts is also assymetrical, what to expect?
im asking this question again, im ready to start glueing and unsure!
#5235