Need help quick on Mamba Max not recognized by Windows
02-28-2007, 06:34 PM
#1
Need help quick on Mamba Max not recognized by Windows
I downloaded the latest 2.23 Castle Link and it suggested a 1.09 firmware update to the ESC.
I told it to update the firmware and Castle Link died in the middle of Step 3. Now I'm stuck with a completely unrecognized and unresponsive ESC. I can't read from it or write to it and Castle Link just says that no device is connected.
When you connect it now, Windows says it's an unrecognized or non-functioning device.
Is this thing trashed?
I told it to update the firmware and Castle Link died in the middle of Step 3. Now I'm stuck with a completely unrecognized and unresponsive ESC. I can't read from it or write to it and Castle Link just says that no device is connected.
When you connect it now, Windows says it's an unrecognized or non-functioning device.
Is this thing trashed?
03-01-2007, 12:18 AM
#2
People were having problems with it, there's a post on rccaraction under the brushless motors forum.
03-01-2007, 07:58 AM
#3
Tech Adept
03-31-2007, 05:51 AM
#4
foolen around
This was the last thread on the list just thought I would give it some attention 
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
