egadsssssss
#1
egadsssssss
got my mf2 running ok but it seems the brush
keeps getting hung, i say this because everytime
i turn my car off the motor light comes on
(its a cobalt) and i push it back in tight and it goes off
and its fast but when its hung its slow and sluggish
but when its back in it only stays in for about 10 seconds around, got any idears?
keeps getting hung, i say this because everytime
i turn my car off the motor light comes on
(its a cobalt) and i push it back in tight and it goes off
and its fast but when its hung its slow and sluggish
but when its back in it only stays in for about 10 seconds around, got any idears?
#3
You are going to have to periodically take the motor apart and give it a good cleaning. The dirt from the track will mix with the bearing oil and gum up the brushes causing the sticking. Get some motor spray and throughly clean the motor and bearings. Then reoil the motor bearings with a
good bearing oil like the royal oil from trinity. This is mandiatory if you want a consistant running motor.
good bearing oil like the royal oil from trinity. This is mandiatory if you want a consistant running motor.
#4
yeah my friend al sponsered by trinity
told me he had the same issue with his motor
so he cut the comm and slapped some new
brushes in and it never happened again, so im gonna try this
told me he had the same issue with his motor
so he cut the comm and slapped some new
brushes in and it never happened again, so im gonna try this