MGM Compro 8012 / Feigao 8s Problem HELP!
I just received a used MGM Compro 8012 & Feigao 8s and I am having problems getting it going. I programmed the controller via the manual, with the leds responding accordingly the entire time.
The minute I connect the motor and try to run it, I get a quick rotation out of the motor and then it goes dead. Same thing happens in forward & reverse, whether it is connected to the truck or spinning freely. I know it is not binding at all as I can spin it freely at any given time. The motor leads seem to be connected to the controller correctly. The manual stated that the motor would beep throughout programming, so I connected the motor and reprogrammed. Throughout the entire thing the leds once again responded, but I did not see any life from the motor. Seeing that this is my first brushless system, I am completely lost. HELP! |
All times are GMT -7. It is currently 01:52 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.