Priming
Hey
I have a Duratrax Nitro Evader BX and im having some problems It wont prime, i put my finger on the exhaust and pull with everything turned off and i see none or sometimes a little bit of gas come up the line and it never goes any farther. i have checked the lien to my pipe and its find. All of the gas that should be goign to my motor is coming out the pipe all over my fingers and my rag when i prime it. Any ideas? by the way Is there suppost to be a gasket inbetween the motor and the pipe? thanks -Ross- |
hmm
take the line of the carb and blow into the exhaust line see if fuel flows freely
then check the carb with another peice of fuel line. blow into the line on the carb and listen for air . has it been sitting for a long time maybe old fuel is blocking the fuel inlet on the carb .. |
Originally Posted by tmaxxking
take the line of the carb and blow into the exhaust line see if fuel flows freely
then check the carb with another peice of fuel line. blow into the line on the carb and listen for air . has it been sitting for a long time maybe old fuel is blocking the fuel inlet on the carb .. |
hmm
i guess i should have said it different ..
make sure the line on the exhaust is long enough for you to pinch if there is too much back pressure from you blowing into the line so you dont get the juice box affect and end up with a mouth full of fuel .. :nod: |
also
also low compression can cause no back pressure into the tank to prime
|
that did it
i put a bike pump through the gas line and this tiem i plugged the line that goes to the exhaust instead of the end and it primed up with about 4 pulls thanks |
All times are GMT -7. It is currently 10:12 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.