Looking for a ROAR racing compliant setup for a Tekno EB48 2.0
#1

Hey there. I'm new on the scene, and I wanted to get your advice on what esc and motor I can race and still be compliant with roar rules. I've really been eyeing the Tekno EB48 2.0 because of the great reviews, simple build, and highly talked about durability. Anyway, any advice you can give is greatly appreciated. Thanks!
#2
Tech Master
iTrader: (19)

Thou I am not that deep into racing yet, roar rules apply to all 1/8 buggies in the class.
Maximum track width, wheelbase, wing, etc
Wheelbase is measured at the centerline of the hub front/rear, track width is measured at the top center point of the wheel no offset, if I am not mistaken.
Maybe different for rc cars thou, as my 8e4 measures about 12.2 inches from tire top shoulder to shoulder
Maximum track width, wheelbase, wing, etc
Wheelbase is measured at the centerline of the hub front/rear, track width is measured at the top center point of the wheel no offset, if I am not mistaken.
Maybe different for rc cars thou, as my 8e4 measures about 12.2 inches from tire top shoulder to shoulder
#5

Any 4s lipo. 5000-6000 should be enough.
1900-2100kv motor.
Car's track width and wheelbase is already adjustable to meet spec. Ask your RD if he's even going to tech this. Almost everyone in outdoors buggy is over the wheelbase spec, unless the rules have changed in the past 22 years.
1900-2100kv motor.
Car's track width and wheelbase is already adjustable to meet spec. Ask your RD if he's even going to tech this. Almost everyone in outdoors buggy is over the wheelbase spec, unless the rules have changed in the past 22 years.