Smallest comm size?
I've been searching, and I can't come up with any info on how small you can safely cut a Monster stock motor.
Anyone have any ifo out there? A link would be great. Thanks, JC |
.270 (inches)
that goes for all motors stock or mod |
I didn't know that....I always just eyeballed it...."um..that looks pretty small, I say toss it..."
hahaha |
Lol yea, ehhh to small.Time to give it to some kid... :nod:
|
Getting a new arm is way cheaper than destroying a diamond bit.
|
Yeah at .270 they run great but your running with a ticking time bomb! :tire:
time for another at that stage |
Yea, Ive seen one of those time bombs go off....number of times actully.Not perty, most of the time the ESC, and all goes up in smoke.
|
Thanks guys. So the one I have been running at .265 is a little small :(
Why would the ESC fry??? |
Cuase once the comm gets so small the outer edge of the bushes are to touch.It going to form a perfect circle around the comm and short out.Only take a second or two of WOT to fry it when shorted.
|
All times are GMT -7. It is currently 12:01 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.