Doug10

iTrader: (2)

I have read through the entire long SC5M official page with no avail, but i have anew SC5M that had leaky lower shock o-rings. Bought associated 91495, the v2 rebuild, and when its together, it seems as though the o-rings do not crush enough when tightened up to properly seal the shaft. When the lower cap is as tight as it goes, the shock still has some slop in the bushings. Seems as though the center spacer between the x-rings needs to be a smudge thicker. Anyone have any suggestions?

rustyus

iTrader: (1)

You could try one of the .03 nylon spacers/limiters in there.
You sure you got the V2 shock parts? I know others were sent the wrong parts by mistake.