did i wire my LATHE 35t motor right?
10-09-2012, 08:31 PM
#1
did i wire my LATHE 35t motor right?
I just cut off my on of switch and solder the 2 wires (black & white together )
and shrink wrapped it so no more worries on the trail
then i wires my lathe motor this way using the stock wires
is that okay??
Red will go on the white wire on the axial Ae-2 esc , and the black on black
let me know if this seems right don't want to burn something
and shrink wrapped it so no more worries on the trail
then i wires my lathe motor this way using the stock wires
is that okay??
Red will go on the white wire on the axial Ae-2 esc , and the black on black
let me know if this seems right don't want to burn something
10-09-2012, 08:58 PM
#2
should be good to go. worst case, motor will go backwards. it wont burn anything up if they are backwards
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
