Quinny45

iTrader: (6)

Sold

Quinny45

iTrader: (6)

Sold !

muddslinger

Getting out of onroad racing. I would like to sell as a complete kit for someone looking to get into rc racing.
raced at over geared racing indoor.
Yokomo bd7 2016 black edition
yokomo yr10f
Mylaps transponders x2
futaba 4pv radio with drop down steering that I never installed plus 2 recievers
hitec x2 ac plus dual lipo charger with power supply and stand
all tools and parts plus setup board and prolinerc hauler bag
$1000 for everything

Swampracer

iTrader: (72)

Schumacher LD2 (carpet) 2wd buggy package

TONs of parts (can almost build a second rolling chassis)
Muchmore Fleta Pro ESC
Sanwa PGS servo
AMB transponder
NO receiver
extra titanium screws, Ti rods, ball ends etc
spur gears, tranny parts
2 NEW JConcepts lite bodies
Abag of uncut and cut wings
Instructions
Aluminum chassis and brace
extra chassis protectors

Rolling chassis

Everything fancy

Chassis and protector

Parts kit

More parts

New JConcepts bodies

Ooooooo fancy

All hop-up parts

All Titanium upgrade bits

only used indoors

$700 including shipping

muddslinger

2 mylaps transponders up for sale

$100 each

local pickup or meet

SteveM

iTrader: (165)

*** SOLD ***

Tamiya 30th Anniversary Ford Mustang GT4 R/C Car

Selling my like new Tamiya Ford Mustang GT4 30th anniversary radio control R/C car.

SteveM

iTrader: (165)

*** SOLD ***

Tamiya Porsche 911 TT-01 Type-E Radio Control Car

Selling my almost new Tamiya Porsche 911 TT-01 Type-E radio control R/C model car.

SteveM

iTrader: (165)

Selling my vintage Novak Millennium battery charger for radio control R/C cars, trucks, and buggies. Also works for R/C airplanes. The Novak Millennium is a complete battery management system designed to get the most performance out of your batteries. With its large, easy-to-read display, the Millennium gives you vital information that is easy to comprehend. The Millennium is equipped with Reverse Pulse Mode for all Ni-Cd cells, Linear Mode for Ni-Cd & Sub-C size Ni-MH cells, and Ni-MH Mode for smaller Ni-MH cells. All three modes are user-adjustable, including the charge rate, delta-peak value, reverse pulse duration, and trickle charge rate (even button and alarm tones).
Case Size ........................................ 4.00” x 4.38” x 2.33” (10.16 x 11.13 x 5.92 cm)
Weight .................................................. .......................... 13.94 ounces (395 grams)
Input Voltage (Power Source) .................................................. ................. 12-15 volts
DC Charging Modes ................................. Linear (Ni-Cd) • Reverse Pulse (Ni-Cd) • Ni-MH
Charging Capability .................................................. ............ 4-8 cells (1.2 VDC/cell)
Ni-Cd Charge Rate (Linear & Reverse Pulse) ................................ 0.5-7.0 amps (adjustable)
Trickle Charge Rate (after linear peak) ........................................... 0.1-0.4 amp (adjustable)
Reverse Pulse Duration .................................................. .............. 5-20 milliseconds
Ni-MH Charge Rate .................................................. ........ 0.5-1.5 amps (adjustable)
Circuit Protection ..... Input RVP, Output RVP & Short-Circuits, Shorted Batteries, Thermal Overload

Selling for $25 CAN and Ottawa, ON area pickup, but willing to ship Canada Post if buyer covers costs. --> NO PayPal, NO USA shipping, E-transfer or cash only, pickup available.

SteveM

iTrader: (165)

Flysky FS-GT3B Radio Controller Set

Selling my like new and used once Flysky FS-GT3B radio control system. Basically new and was used just once in a Tamiya TT-01 R/C car at an indoor carpet track. Still has the protective clear film on the LCD screen. Comes in the box with everything just like brand new and I am including a second receiver as well that works perfectly with this radio. Ottawa area pickup, but will ship if buyer covers the cost. $65 CAN, no PayPal, no USA shipping, e-transfer or cash in person pickup.

SteveM

iTrader: (165)

>>> SOLD <<<

Selling a new never used Spektrum SR301 2.4gHz receiver. Comes as shown and local Ottawa area pickup. I will ship if buyer covers costs.

Key Features
- 3-channel DSM® sport surface receiver
- Reliakote™ water-resistant coating provides electronics with protection from water, fuel and motor spray
- Compact, fuelproof case and lightweight design allow for installation in nearly any car or truck

$20 Canadian, NO PayPal, NO USA shipping, cash on pickup in Ottawa, ON, will ship if buyer covers costs.

stubaxle

iTrader: (2)

SC10 6.1 Roller, run about 4 times. Includes parts for all 3 transmission options (many BNIP, at most all have very little use) which are not easy nor cheap to source. BNIP Exotek front bulkhead, all tuning parts that came in the box. Also the box, manual (i am certain i have it here somewhere) decals, good body (few grazes) and 3 pairs of premount Blockades (maybe 4 if i can find the other pair) all very minimal wear. $500 OBO.








Can be made ARTR, please PM for details. Thanks for looking!

stubaxle

iTrader: (2)

Associated B5M roller, used but in great condition. Spares include gullwing front arms and shock tower, springs and anti-roll bars shown, full set of spring perches and all the rest that is shown. Tyres are Blockades and Impacts, 4 Ribs and Rips, all have 70+% tread left. Bodies are all well usable. $250 OBO, can be made ARTR, PM for details. Thanks for looking!

aer52

iTrader: (3)

Removed

evoevo58

iTrader: (6)

Selling 2 older AMB Transponders...$SOLD for both.

bRIBEGuy

iTrader: (1)

Up for sale is a rare vintage Robbe Klack Formel Racer from 1988. This was a rebranded variant of the Kyosho Raider buggy.

The buggy is in fair condition, and would be a good candidate for a restoration. I have an old Futaba Attack radio that can be included if requested.

The box for the buggy is amazing, and is in quite good shape for being 34 years old! Metal hinges and claps, create a "suitcase"-like packaging. Very unique, and a great collectable in and of itself. Includes some original stickers, and the original manual as well.

Very unique piece of RC history.

I'd love to keep and restore this, but I have too many projects already, and I was never really a big "Kyosho" guy.

Asking $200 (cad) + shipping (Located near Calgary, Alberta).