Adelaide Nitro Offroad Racing Club

Here is a little back story.
I put this engine in maybe three years ago. Ran 1/4 gallon through it before I ran another half gallon of a special break-in blend my LHS perscribed. The enging over heated to the point of melting 3 pull starts. Before i shut it down. When I started the engine up last month. I had to replace the slipper clutch, glow plug, and spur gear. I am running 33% in it now. And have been through 1/2 gallon of that so far. I running 16t clutch bell. And have used a 38t 40t and now a 36t spur. I can not remember which gear set i have installed. I have the center diff. And CV drive train.
I still can not get a good launch or great speed from this thing. My 3.3 honestly gave me more. I am afraid to lean out either needle too much as i learned they were lean from the begining and thats why it overheated before. I am getting lots of blue smoke. So i think i can lean out more. As it seems to be a bit too much smoke. I am ready to throw this thing out. ANY HELP WOULD BE GREATLY APPRICIATED. PLEASE HELP!
I put this engine in maybe three years ago. Ran 1/4 gallon through it before I ran another half gallon of a special break-in blend my LHS perscribed. The enging over heated to the point of melting 3 pull starts. Before i shut it down. When I started the engine up last month. I had to replace the slipper clutch, glow plug, and spur gear. I am running 33% in it now. And have been through 1/2 gallon of that so far. I running 16t clutch bell. And have used a 38t 40t and now a 36t spur. I can not remember which gear set i have installed. I have the center diff. And CV drive train.
I still can not get a good launch or great speed from this thing. My 3.3 honestly gave me more. I am afraid to lean out either needle too much as i learned they were lean from the begining and thats why it overheated before. I am getting lots of blue smoke. So i think i can lean out more. As it seems to be a bit too much smoke. I am ready to throw this thing out. ANY HELP WOULD BE GREATLY APPRICIATED. PLEASE HELP!
Sounds like your not having much luck with your car, your best bet would be to attend a CLUB meeting, there is A lot off Good knowledge first hand that will be able to help you out!!
Club meeting This Sunday 21/2, from 9am onwards!

TOMORROW'S RACE DAY SCEDULE
8.30 – NOMINATIONS OPEN
----ARRIVE AND SET UP OF PERSONAL EQUIPMENT----
9.00 – NOMINATIONS CLOSED
-------- $10.00 LATE FEE AFTER NOMINATIONS CLOSE--------
------ UNLESS PRIOR ARRANGEMENT WITH COMMITTEE----
9.00 – TRACK SET UP
-------- EVERYONE TO ASSIST, NO EXCEPTIONS--------
9.30 – DRIVERS BRIEFING
9.35 – OPEN PRACTISE
9.55 – PRACTISE CLOSED
10.00 – RACING STARTS
12.30 – LUNCH BREAK
1.00 – RACING RESUMES
4.30 – RACING FINISHES
8.30 – NOMINATIONS OPEN
----ARRIVE AND SET UP OF PERSONAL EQUIPMENT----
9.00 – NOMINATIONS CLOSED
-------- $10.00 LATE FEE AFTER NOMINATIONS CLOSE--------
------ UNLESS PRIOR ARRANGEMENT WITH COMMITTEE----
9.00 – TRACK SET UP
-------- EVERYONE TO ASSIST, NO EXCEPTIONS--------
9.30 – DRIVERS BRIEFING
9.35 – OPEN PRACTISE
9.55 – PRACTISE CLOSED
10.00 – RACING STARTS
12.30 – LUNCH BREAK
1.00 – RACING RESUMES
4.30 – RACING FINISHES
Last edited by friend2friend; 02-19-2016 at 11:50 PM.
Tech Adept
iTrader: (6)

Port Lincoln, Round 1 of the Neo+ Fuel State Series is still going ahead on the 27th and 28th of February.
Please forward all entries to [email protected]. Entry fees are $30 first class, $20 second class payable on the day.
Please send through your name and transponder number, and if you could send club details would also be good.
We did start a club championship which runs on highest points scored by a club over the weekend which hasn't been done for the last couple of years. Come and help get your clubs name on the plate in 2016!
Please forward all entries to [email protected]. Entry fees are $30 first class, $20 second class payable on the day.
Please send through your name and transponder number, and if you could send club details would also be good.
We did start a club championship which runs on highest points scored by a club over the weekend which hasn't been done for the last couple of years. Come and help get your clubs name on the plate in 2016!
Tech Master
iTrader: (30)

TOMORROW'S RACE DAY SCEDULE
8.30 – NOMINATIONS OPEN
----ARRIVE AND SET UP OF PERSONAL EQUIPMENT----
9.00 – NOMINATIONS CLOSED
-------- $10.00 LATE FEE AFTER NOMINATIONS CLOSE--------
------ UNLESS PRIOR ARRANGEMENT WITH COMMITTEE----
9.00 – TRACK SET UP
-------- EVERYONE TO ASSIST, NO EXCEPTIONS--------
9.30 – DRIVERS BRIEFING
9.35 – OPEN PRACTISE
9.55 – PRACTISE CLOSED
10.00 – RACING STARTS
12.30 – LUNCH BREAK
1.00 – RACING RESUMES
4.30 – RACING FINISHES
8.30 – NOMINATIONS OPEN
----ARRIVE AND SET UP OF PERSONAL EQUIPMENT----
9.00 – NOMINATIONS CLOSED
-------- $10.00 LATE FEE AFTER NOMINATIONS CLOSE--------
------ UNLESS PRIOR ARRANGEMENT WITH COMMITTEE----
9.00 – TRACK SET UP
-------- EVERYONE TO ASSIST, NO EXCEPTIONS--------
9.30 – DRIVERS BRIEFING
9.35 – OPEN PRACTISE
9.55 – PRACTISE CLOSED
10.00 – RACING STARTS
12.30 – LUNCH BREAK
1.00 – RACING RESUMES
4.30 – RACING FINISHES

...Thank You to all who attended today's race meet...
...Pt Lincoln Neo next weekend 27th & 28th Feb...
...........So let get a few more to make the trip........
SDMCC Next Race Meet --- Sunday 6th March
SDMCC Track Work --- 12th & 13th March
SA STATE TITLES --- 19th & 20th March
...........So let get a few more to make the trip........
SDMCC Next Race Meet --- Sunday 6th March
SDMCC Track Work --- 12th & 13th March
SA STATE TITLES --- 19th & 20th March

GET THOSE ENTRIES IN GUYS
Tech Master
iTrader: (27)

RACING THIS SUNDAY 6 MARCH
TRACK WORKING BEE SATURDAY 12TH & SUNDAY 13TH
IF WE COULD GET SOME HELP ON THE SATURDAY MORNING TO REMOVE THE ROPES THAT WOULD BE GREAT
TRACK WORKING BEE SATURDAY 12TH & SUNDAY 13TH
IF WE COULD GET SOME HELP ON THE SATURDAY MORNING TO REMOVE THE ROPES THAT WOULD BE GREAT

Due to expected hot weather and Lack of people available with club equipment to run, RACING IS CANCELLED FOR TOMORROW.....sorry for those who wanted to attend...
Tech Master
iTrader: (20)

Dam I have brought deodorant and showered!!!!!!

WORKING BEE THIS WEEKEND 12th & 13th
WE ALL USE THE TRACK ONLY FAIR EVERYONE HELPS
Will be in need of a trailer to remove old carpet under rostrum
Can you please let me know if you can assist with the trailer on 0421515691
[/CENTER]
WE ALL USE THE TRACK ONLY FAIR EVERYONE HELPS
Will be in need of a trailer to remove old carpet under rostrum
Can you please let me know if you can assist with the trailer on 0421515691
Tech Addict
iTrader: (26)

I was thinking of entering E buggy are there enough entries to run at SA titles?
Tech Addict
iTrader: (26)

ok cool
Im in
Im in

Tech Addict
iTrader: (26)

Any pics of the track after the working bee?
Have there been any changes to the layout or jumps?
cheers
Have there been any changes to the layout or jumps?
cheers