SMA Night Racing
#2147
Tech Champion
iTrader: (10)
ive got a better idea cristian how about we hire tom.b when ever it rains!!! The hot air coming out of his mouth will dry the track real fast!!!! on the down side we may have to scrap up a few bit of S##t that fall out too!!! small price to pay for a dry track !! ill chip in!!
good one phi-phi box, or corey the great, whoever the hell you are.
#2148
Tech Elite
iTrader: (73)
I have just been down to the track and there is still large amounts of surface water covering key sections of the track (quite deep in sections).
Subsequently, there will be no timed racing tonight. However, for those who are keen to mop up the water and run some practice, you are very welcome.
As the forecast is looking pretty good for the weekend, I will be at the track on Saturday (time to be confirmed) to mop up any water so we can race on Sunday. It would be good if a few members can make themselves avialable
Subsequently, there will be no timed racing tonight. However, for those who are keen to mop up the water and run some practice, you are very welcome.
As the forecast is looking pretty good for the weekend, I will be at the track on Saturday (time to be confirmed) to mop up any water so we can race on Sunday. It would be good if a few members can make themselves avialable
#2149
YES
Yes we need this thread ,I havent figured out what for yet
#2150
the weather
Has already seen tuesdays weather ,not saying a word
#2151
tomorrow night
Dought Ill be there tomorrow night to cold.
If I race again wont be till it warms up.
If I race again wont be till it warms up.
#2154
geez were did you dig this thread up from, must of been 20 pages back
no racing tommorow night, the following Tuesday we will race
no racing tommorow night, the following Tuesday we will race
#2155
it is a practice nite though if enough show up.
#2157
this thread
I here by claim this thread and all who sail in her
If its warm tomorrow I might have a run.
Den its not my lathe but Ill see.
If its warm tomorrow I might have a run.
Den its not my lathe but Ill see.
#2159
barts/scott
Scotty ,we close at 5.30.should have pinions but dont quote me on that