"Im an ideas man" thread
#1
"Im an ideas man" thread
ok guys just thought i would add something to our section...
Quick track fixes, ideas that have worked for you,hints and tips, anything that stops us buying over priced products and general friendly info.....
Well i will start it off for all the tradies out there..just cut some wedges of timber into 1, 1.5 ,2,2.5,3 degree angles on your mitre saw for camber angles and toe angles....all at the price of...the bosses expense!
also i found that the rubber sleeves that are used to hold drill bits(hex driver bits) in are rubber and the same size as fuel tubing so they make good line holders etc... i used them and saved some dough on over priced breakable stuff....see below
like the link says Ideas man.. share with us your great fixes and inventions..
Quick track fixes, ideas that have worked for you,hints and tips, anything that stops us buying over priced products and general friendly info.....
Well i will start it off for all the tradies out there..just cut some wedges of timber into 1, 1.5 ,2,2.5,3 degree angles on your mitre saw for camber angles and toe angles....all at the price of...the bosses expense!
also i found that the rubber sleeves that are used to hold drill bits(hex driver bits) in are rubber and the same size as fuel tubing so they make good line holders etc... i used them and saved some dough on over priced breakable stuff....see below
like the link says Ideas man.. share with us your great fixes and inventions..
Last edited by cotto68; 09-08-2010 at 10:03 AM.