Where are all the 4600NiMh Cells???
#3
I heard that there is a guy going around selling them, he also sells wooden clubs and dinosaur traps
#5
buy them
Can i by these for my mini, will they go betta with 4600 than the 4200 i have now ???
#7
we are running 1 cell lipo in 1/12th and its awesome.
You buy a IB4200mah lipo saddle pack and you instantly get 2 single cells for your 1/12th.
you make 8 mins with no problem at all in mod. you do need a quicker motor than previously but you can run with a 5.0 and be competitive if the track does not have a huge straight.
we even spoke to peter ellis about using them at sanctioned events and he saw no issue as long as you made minimum weight.
forget the torch batteries and move on to 1 cell lipo
You buy a IB4200mah lipo saddle pack and you instantly get 2 single cells for your 1/12th.
you make 8 mins with no problem at all in mod. you do need a quicker motor than previously but you can run with a 5.0 and be competitive if the track does not have a huge straight.
we even spoke to peter ellis about using them at sanctioned events and he saw no issue as long as you made minimum weight.
forget the torch batteries and move on to 1 cell lipo
#8
#9
we are running 1 cell lipo in 1/12th and its awesome.
You buy a IB4200mah lipo saddle pack and you instantly get 2 single cells for your 1/12th.
you make 8 mins with no problem at all in mod. you do need a quicker motor than previously but you can run with a 5.0 and be competitive if the track does not have a huge straight.
we even spoke to peter ellis about using them at sanctioned events and he saw no issue as long as you made minimum weight.
forget the torch batteries and move on to 1 cell lipo
You buy a IB4200mah lipo saddle pack and you instantly get 2 single cells for your 1/12th.
you make 8 mins with no problem at all in mod. you do need a quicker motor than previously but you can run with a 5.0 and be competitive if the track does not have a huge straight.
we even spoke to peter ellis about using them at sanctioned events and he saw no issue as long as you made minimum weight.
forget the torch batteries and move on to 1 cell lipo
What esc are you using? Any rx packs? what motor wind is the go? anyone melted a LIPO from over discharge yet? Do you need to be careful about the thottle to make run time or can you be heavy handed like I am?
Is there any official word anywhere from AARCMCC about this on the forums? My main concern would be over discharge protection as it is a requirement in thr "official" rules for 2s lipos to be protected by esc or external measure, and would assume this would be required for the 1s systems also. I am all for this if possible and think that the 6000mah packs look real tasty for this purpose
#10
Tech Champion
iTrader: (34)
AndyM did the maths for me a while back on the 1 cell, to get the same RPM as the 6.5s most of us run at 4.8v you need a 3.5 turn motor. According to people in the states and UK, run time is an issue with turns that low (with the SMC 4000 pack anyway), but compared to carpet we hardly use the throttle so I reckon it'll be sweet. I think I'll still wait till some other manufacturers jump on the 1 cell bandwagon and offer 5000mah+
#12
Before anyone says anything it was the only mod B/L I had so that whay I ran it, and yes it was way too fast for me, but somehow really good fun at the same time!
#13
Tech Champion
iTrader: (35)
Dont forget that the capacity figure is measured differently between Nimh and lipo ... Lipo is from fully charged down to the 6 volt cutoff (or 3 volt in the case of the 1S.
Nimh I believe is measured from fully charged to zero. Hence the apparent greater capacity of a lipo for a nominated capacity compared to a nimh
Nimh I believe is measured from fully charged to zero. Hence the apparent greater capacity of a lipo for a nominated capacity compared to a nimh
#14
Tell me more-I have seen the thread in the international section but CBF reading the million or so pages....
What esc are you using? Any rx packs? what motor wind is the go? anyone melted a LIPO from over discharge yet? Do you need to be careful about the thottle to make run time or can you be heavy handed like I am?
Is there any official word anywhere from AARCMCC about this on the forums? My main concern would be over discharge protection as it is a requirement in thr "official" rules for 2s lipos to be protected by esc or external measure, and would assume this would be required for the 1s systems also. I am all for this if possible and think that the 6000mah packs look real tasty for this purpose
What esc are you using? Any rx packs? what motor wind is the go? anyone melted a LIPO from over discharge yet? Do you need to be careful about the thottle to make run time or can you be heavy handed like I am?
Is there any official word anywhere from AARCMCC about this on the forums? My main concern would be over discharge protection as it is a requirement in thr "official" rules for 2s lipos to be protected by esc or external measure, and would assume this would be required for the 1s systems also. I am all for this if possible and think that the 6000mah packs look real tasty for this purpose
Could be to late for the State Titles or maybe not.
#15
Company Representative
iTrader: (44)
Here's what Trev is talking about: http://teamnovak.com/products/smart_boost/index.html
Hope to see these next month some time.
As Ben has said you can run without it and finish the race with no issues, UNLESS its a large track... dont think many would make time at tracks like ACT.
...Ari
Hope to see these next month some time.
As Ben has said you can run without it and finish the race with no issues, UNLESS its a large track... dont think many would make time at tracks like ACT.
...Ari