*Durango DEX408, plus spares* SOLD
#1
*Durango DEX408, plus spares* SOLD
****SOLD****
my DEX408
always run on carpet, had a few runs maybe 20 or so batteries, see pics below
tekin gen2 1/8th esc,
tekin gen2 1/8th motor, 2050kv
titanium coated shafts
alu wing washers
from day 1 the chassis has always had this adhesive protector on it, underneather is like new no scratches,
also has rear skid plate
can be used with sadel packs
or stick packs, wire extensions included
40mm zepping fan, mounted on side "pod/rail" plastic bit
counter sunk screws so the body stays nice and fresh
some springs, stock black ones and some white ones, not sure the spring rate but the color is green and blue,
stock shock shafts never used
plastic bits, stock hubs and shock pistons, and a 21t pinion
more plastics, all optional toe/kickup inserts for front and rear, boots never used, and some shims, c clips for the diffs
tekin hot wire for the esc
tires included are some aka Enduros and Jconsepts subcultures in soft compound, also included is a wheel wrench for the durango wheels, had to shave it down as the durango wheels have a lip around the wheel nut to protect it.
when i built the car the diffs have been shimmed out to minimize wear on the gears, also the shock caps have been modded, a 1mm hole in the top and top foams added, found this to make shock building much easier. the steering plate has also been modded, instead of stock bushings ive replaced them with bearings and slightly longer screws, other then that its been just been raced on carpet, never bashed on dirt
asking $350 plush postage ONO, lipos can be included at 50$ a pair, the saddles or sticks
pm with offers, or you can email me at [email protected]
thanks for looking
my DEX408
always run on carpet, had a few runs maybe 20 or so batteries, see pics below
tekin gen2 1/8th esc,
tekin gen2 1/8th motor, 2050kv
titanium coated shafts
alu wing washers
from day 1 the chassis has always had this adhesive protector on it, underneather is like new no scratches,
also has rear skid plate
can be used with sadel packs
or stick packs, wire extensions included
40mm zepping fan, mounted on side "pod/rail" plastic bit
counter sunk screws so the body stays nice and fresh
some springs, stock black ones and some white ones, not sure the spring rate but the color is green and blue,
stock shock shafts never used
plastic bits, stock hubs and shock pistons, and a 21t pinion
more plastics, all optional toe/kickup inserts for front and rear, boots never used, and some shims, c clips for the diffs
tekin hot wire for the esc
tires included are some aka Enduros and Jconsepts subcultures in soft compound, also included is a wheel wrench for the durango wheels, had to shave it down as the durango wheels have a lip around the wheel nut to protect it.
when i built the car the diffs have been shimmed out to minimize wear on the gears, also the shock caps have been modded, a 1mm hole in the top and top foams added, found this to make shock building much easier. the steering plate has also been modded, instead of stock bushings ive replaced them with bearings and slightly longer screws, other then that its been just been raced on carpet, never bashed on dirt
asking $350 plush postage ONO, lipos can be included at 50$ a pair, the saddles or sticks
pm with offers, or you can email me at [email protected]
thanks for looking
Last edited by redthunder; 09-03-2014 at 11:27 PM. Reason: SOLD