betson

Hey All,
Looking to sell or trade my 1/8 offroad setups for a near new 1/5 4WD HPI Baja truck or buggy, if your keen on downsizing a bit txt me on 0434207939 or PM (prefer txt)

I've got-
Hyper 8.5 Pro with heaps of spares, got this setup going to race but never got time. Only done half a dozen or so tanks with this chassis, the motor has done a bit of work though.
Includes-
HS645MG steering servo, hobao servo on throttle/brake
RB WS72, done some work but still peaks and pulls hard
Big Bore 22mm shocks
spider centre diff
Skid plates, carbon fibre servo tray etc.
Pro steering knuckles and suspension arm mounts
Bucket of tyres and wheels, nearly new set of bowties in there, hard badlands mounted.
Spektrum RX
Heaps of spares, front and rear arms, screws, etc etc.

Bind n Go race setup with enough spares for alot of racing. With a bit of tuning chassis wise this will be a quick car, I never really had time to muck around with camber, toe in etc etc.

700 for the lot

Mugen MBX5T
HS645MG servo's
RB WS73- Quite fresh, been run in and had maybe 4-5 tanks after that.
Big bore shocks
Spektrum RX
Spare front and rear arms.

This is another Bind n Go setup, very fun to drive and nice and quick.
Looking for 550 for the mugen.

Will try and get some pics up here tomorrow, if you are interested txt me and I'll send through some photo's.

Located in sth gippsland, but can freight or post at buyer expense

Cheers
Mick

betson

8.5 PRO Photos,
Not pictured- Starter box, spare used wheel and tyres

betson

MBX5T photos,
Will require a starter/bump box if this is purchased on it's own.

I found a spare set of wheels with mounted tyres, the are used.