1/8 Bazooka (pangolin) buggy and spares
#1
1/8 Bazooka (pangolin) buggy and spares
hi this is an unfortunate decision to finally sell my buggy
it have had it for a couple of years and its been great, its never had a race but bashed when my truggy wanst going.
it comes with :
- SH21 engine (the stock engine) pullstart is broken
- habao MACSTAR 28 (6 port engine) back plate for bump start and i have the pullstart but again broken
- 2 x basic servos (i think MG955)
- spare carbi (from a CEN 28 engine)
-proline crimefighters ( only used on grass) never raced about 95% tread
- original tyres (worn out bad used on road)
- great vigor failsafe
- stock exhaust
- 27mhz Hitc Agressor TX/RX (have not used for a long time rubber around wheel perished)
- Original 27mhz radio
- spare glow plugs for the engines (some used, some new)
i will also throw in a starter box, its a H.A.R.D racing starter (dont need it anymore as i have an Ofna twin motor)
the reason im selling is because i need to find another CEN truggy to use as a spare and have parts as they are begining to become hard or pricey to get
i am looking at around $120 plus postage
any questions ask me and i will reply as best i can
cheers Mark
it have had it for a couple of years and its been great, its never had a race but bashed when my truggy wanst going.
it comes with :
- SH21 engine (the stock engine) pullstart is broken
- habao MACSTAR 28 (6 port engine) back plate for bump start and i have the pullstart but again broken
- 2 x basic servos (i think MG955)
- spare carbi (from a CEN 28 engine)
-proline crimefighters ( only used on grass) never raced about 95% tread
- original tyres (worn out bad used on road)
- great vigor failsafe
- stock exhaust
- 27mhz Hitc Agressor TX/RX (have not used for a long time rubber around wheel perished)
- Original 27mhz radio
- spare glow plugs for the engines (some used, some new)
i will also throw in a starter box, its a H.A.R.D racing starter (dont need it anymore as i have an Ofna twin motor)
the reason im selling is because i need to find another CEN truggy to use as a spare and have parts as they are begining to become hard or pricey to get
i am looking at around $120 plus postage
any questions ask me and i will reply as best i can
cheers Mark
Last edited by hammerbugg; 08-25-2011 at 09:25 PM. Reason: edit