Kyosho FW-05RR RTR - EOI.
#1
Kyosho FW-05RR Evo2 RTR
I have For Sale a excellent condition FW-05RR Evo2 (According to the sticker on the Kyosho box)
Will come ARTR with the following. All that's required is a transmitter & receiver.
- KO Propo 2413 (Throttle), and JR DS8511 (Steering) servo's.
- GXR15 - Almost run in, another two tanks underload required.
- Kyosho Viscous Diff upgrade.
- Q-World starter box, with front panel - Just rebuilt. Will require a 12v Gel Cell, or 3s Lipo.
- New cut, sanded & prepped Mazda6 body - Unpainted.
- Bunch of spares & parts - As per picture.
- Alloy V-One RRR Evo wheel hex's
- Ti Pillow balls & V-One RRR Evo nuts.
- Carbon Fibre steering plate.
- Carbon Fibre front shock tower (Tried to fit a FW-05RR rear carbon tower, but doesn't fit the Evo2)
- Team Solar clutch nut & spring, allowed me to bolt a 3d Clutch kit upto the GXR15. (will require fine adjusting.)
- Alloy transmission case w/ carbon fibre brace.
- Kyosho GXR15 backing plate to remove the pullstart (should slightly increase power)
- Tuned pipe kit (Needs to have the manifold port matched as its new)
- Will throw in a glow driver & Charger.
The car has just been rebuilt, with parts that needed replacing, replaced.
Has seen two laps on the KROMA (Keilor) track since rebuild, engine still needs 2-3 tanks run through it on the track before a proper tune - has seen 3 on the bench.
Open to offers - No low ballers though.
Thanks,
John.
----------------------------------------------------------------------------------------
Will come ARTR with the following. All that's required is a transmitter & receiver.
- KO Propo 2413 (Throttle), and JR DS8511 (Steering) servo's.
- GXR15 - Almost run in, another two tanks underload required.
- Kyosho Viscous Diff upgrade.
- Q-World starter box, with front panel - Just rebuilt. Will require a 12v Gel Cell, or 3s Lipo.
- New cut, sanded & prepped Mazda6 body - Unpainted.
- Bunch of spares & parts - As per picture.
- Alloy V-One RRR Evo wheel hex's
- Ti Pillow balls & V-One RRR Evo nuts.
- Carbon Fibre steering plate.
- Carbon Fibre front shock tower (Tried to fit a FW-05RR rear carbon tower, but doesn't fit the Evo2)
- Team Solar clutch nut & spring, allowed me to bolt a 3d Clutch kit upto the GXR15. (will require fine adjusting.)
- Alloy transmission case w/ carbon fibre brace.
- Kyosho GXR15 backing plate to remove the pullstart (should slightly increase power)
- Tuned pipe kit (Needs to have the manifold port matched as its new)
- Will throw in a glow driver & Charger.
The car has just been rebuilt, with parts that needed replacing, replaced.
Has seen two laps on the KROMA (Keilor) track since rebuild, engine still needs 2-3 tanks run through it on the track before a proper tune - has seen 3 on the bench.
Open to offers - No low ballers though.
Thanks,
John.
----------------------------------------------------------------------------------------
Last edited by [[john]]; 10-18-2010 at 09:26 PM.
#13
fw05rr
hello, I wonder if the chassis, of, fw05rr, is still the sale?