Mighty Mini servo question.....
 

I've just purchased one of these servos for my first 1/12th car and along with it a Kimbrough servo saver.

The only problem is the screw provided with the servo is to short to go through the servo saver and then more than a couple of turns into the servo output.

Could someone let me know the correct sizing of the screw/thread so I can try and find another one but just a little longer?

None of the other servo screws I have seem to fit properly and this is not something I think I should just guess lol.

Never mind.....
 

accidentally dropped it on floor (unfortunately concrete) and the whole servo shattered making the question rather redundant it seems. :cry:

Just not my day. :(

WOW.....sorry for the bad luck...

Did just the case break?

Well that depends lol :( .....
 

I'm not to sure if it's considered part of the case or not but the "middle layer" (you know the bit that the gears mount on) cracked as well.

Hope that makes sense.