Any Topic Thread.
 

Hey guys. post any questions you have about anything related to Hitec products here. Instead of starting a new thread pls use this one, I only get notice to any thread that I am subscribed to, not to the forum in general. TTYL.


Gary F, Team Hitec.

Thanks for your quick response. I will be in edmonton today and now I know what should work.
Mike

No Prob Mike, let me know how it goes and what you went with. TTYL..

Gary F.

i need help getting radios for a hobby shop im opening. i sent you a pm with the details

Gary: What will the New Digital servo programmer/Analog servo checker that you guys will be releasing allow you to adjust on digital servos and what can you check on analog servos with it? What kinds of info will it give?

I am not 100% sure yet on all its functions. I don't have mine yet so I have very limited exposure to it so far. It will be able to program Fail Safe into the servo, EPA, and other functions. As soon as I get mine i will let you guys know exactly what it can do. TTYL.


Gary F.

Hey Gary, I pluged my batts back into my 3D last night.... and i heard a nice "poof" ..... radio never turned on... but now i have the nice "burnt electronics" smell coming from it.

I'm sending it in tommorow, about how long should it be untill i get it back? Less that 2 weeks? .... i hope..lol

oh and address.... this one righthttp://www.hitecrcd.com/ServSup/address.gif

thanks..

yah, turn around should be under 2 weeks. And yes that is the right addy for us. Don't ya just hate that smell!! Did you put the batts in backwards by chance? heh. TTYL.


Gary F.

putting batts in backwards isnt possible as far as i know... Isnt it setup so no matter what, just aslong as the middle wire doesnt get put on the outside?

i have the nicad pack....

oh well... yes.. that smell SUCKS!!!

worst thing is i also lost my real-time 2 equal tray on the same night... costly night :(

Hey Gary, can you shout at Mike to check his e-mail? I'm having problems on the Hitec website. :(

I'm going to send in my 3D later this week, most likely wednesday.

I have a MS 605MG servo and I noticed that it does center its self after I turn on to the straight I race on carpet with a TC3 I use a cyclone TC and a novak receiver I use the bushings on the steering rack any ideas why this happening??? Thanks alot

Troy, we were having some probs with our server. We were changing a piece but it didn't go as smooth as hoped. His email should be working now tho, I sent him some this afternoon.


MM, when the servo is disconnected is your steering free or does it seem like its binding a bit?



Gary F.

Gary - Ok... I couldnt get my password on the Hitec bb, then it wouldnt let me register.

Is it ok to send jut the radio in, no receiver, ect... Its only the radio that poofed, and the receiver is fine.

yes that will be fine. I'm sure we have one or two receivers kickin around somewhere for testing, Hehe.


Gary

hehe, ok.. Blaahh.... shipping is a pain in the tooty... I'm going to disconnect the battery too.... i dont want it going poofy on its way and destroying what little pc boad might be left. :D

Truthfully this *almost* helps me out. I was going to race in a week & 1/2, but i needed tires and some other stuff... now that expense is put off for a couple weeks. By then i'll have another paycheck...lol.. dern expensive hobbies..:cool:

Well i gotta go, nice having the little "chat" ... Cya later