Multiplex Rhino Digi 4 8mm Billet Servo Horn
 

First off apologies if this is the incorrect forum for this question but I seem to recall that there is an association between Hitec and Multiplex so hopefully someone here will be able to answer.

Does anyone in the US make an 8mm aluminum servo horn that will work with the Rhino Digi 4 used for steering in an HPI Baja? Thanks.

You mean this?

yup - that's the only one I've seen and seems only can be ordered overseas. I'm really looking for this type of solution in an aluminum *bling* horn :)

http://www2.gpmd.com/image/h/hpic5461.jpg

Edited: Correction, the spline was changed on this servo. The HS805/815 hitec servo horns would fit this servo but are not aluminum.
#56318

Brendan - thanks for the reply. Am I correct in assuming the Rhino Digi 4 quarter scale servo uses an 8mm spline? Also, I looked at Airwild's product line and it's not entirely clear to me if they carry an 8mm spline arm. I have e-mailed them to be certain. I'll post back here with what I find out. Thanks again for the assist.

PM sent