615bb
 

I recently pciked up a 3pj + some servos. Most work ok, but I'm having a problem with one of them. Its a 615BB, and WHENEVER I have my power switch on, it starts turning to the left, without an prompt from my Tx, I plug in another servo and it works fine, put the 615BB back in: same thing. I took the servo apart to take a look @ the gears: and they look fine, the wires look fine [no frays, etc]. When I connected the servo with the gears removed, the thing just kept on spinning!!! Its a pretty decent servo [I have 615BB converted to MG in my RC10GT and I LOVE it: MG conversion b/c the first day I had it the nylon gears stripped] and I'd like to salvage it rather than just trashing it. Thanks in advance!

it sounds like you have the servo plugged in backwards. Try plugging in the servo the other way. TTYl.


Gary F.

Tried that too. and verified plug config. At one point I got mad @ it and decided to try all 3 pins in every combo. The only way I could get it to respond is the way it is. Any more ideas?

Send it in to us and we'll get it fixed up for ya, more than likely under our warranty. Since you've checked the pin config on it it must be someting inside. TTYL.


Gary F.

Gary- Thanks man. Can I get the info on were to ship it to? I think it might be out of warranty; since the servo doesn't have the 'newer' stickered top, rather its all black with the place were it says what model it is it pressed in with model info.

Its NOT the one that looks like this : http://www.gpmd.com/images/hrcm1042.JPG

Thanks in advance!!

phdeez:

http://www.hitecrcd.com/ServSup/address.gif


For more info on Warranty go to:
http://www.hitecrcd.com/ServSup/warranty.htm

1 final question. Since I it from someone else, I don't have a receipt, will that be a problem? THX!!

????
Good question..

Give them a call @ (858)748-8440 and ask, just to be on the safe...

or drop an email: [email protected]

hope this helps....