R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   3D Printing Forum (https://www.rctech.net/forum/3d-printing-forum-194/)
-   -   Copy and Print??? (https://www.rctech.net/forum/3d-printing-forum/1109345-copy-print.html)

wely324 02-04-2023 08:08 AM

Copy and Print???
 
Hi, Iím looking for some info on copying a plastic piece and 3d printing it. The part is from a starter box. It doesnít seem to intricate. I circled the part in the picture, it also has three plastic posts that extend down into the box.

Iím not familiar to 3d printing. I have the part to copy, is there software that copies the design or would I have to make the design in the computer?

Thanks for any help.


All times are GMT -7. It is currently 03:15 PM.

Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.