Power supply guard
Wandering if anyone here prints the plastic front guard/protectors for the standard converted server psu’s we use?
I searched and found an old thread where a member did a couple different ones ae, tekno etc. and tried reaching out to him but never heard back. So if anyone can print me a couple for a decent price or direct me to someone I’d appreciate it. |
Two questions:
1) Whereabouts are you located? 2) Did you have a specific design in mind? Link to design or STL file(s)? Answering these might connect you with someone. Depending on where you are, there might be a commercial service. |
This is a basic one I did. It’s two pieces up front and I glued it together. If your interested
(Or anyone) I can dig up the file and print/mail it as well as some of the carbon fiber vinyl as well so you don’t have to buy a full roll. https://cimg8.ibsrv.net/gimg/www.rct...505621a6f.jpeg https://cimg9.ibsrv.net/gimg/www.rct...f8b3a3d21.jpeg https://cimg0.ibsrv.net/gimg/www.rct...687f34d73.jpeg |
Thanks sacmiata for sharing valuable information.
|
All times are GMT -7. It is currently 03:13 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.