eXpress Motorsports
Tech Champion
iTrader: (42)
Charging.. Tray before charging ( I use the Trinity DPD on Linar 5 amps to 0.70 per cell).. Charge at 6amps with .02 peak detect.. After running discharge down to 5.40 (0.90 per cell ..6 cell)unless not running for a few weeks than I would leave pack with 500 sec of charge in them.. Charge temps do vary but I have seen 150* upon charging..
Hope this helps....
Hope this helps....
Tech Addict
150F on charging... Man that's crazy. Suprising that they don't vent all over the place. I'm quite impressed with how tough the new cells are now from IB.
Tony
Tony
Originally Posted by punkboy
Dang, only 3 tanks and the tires are already bald Sounds like there's not much difference between break in mode and wfo for you brandon
Did you at least let it idle around for the first tank?
Did you at least let it idle around for the first tank?
Idle, hell it won't even do that now, lol. Have to figure out why.
Schreff- From idle when I gig it full punch, it stalls for split second, then revs and goes. Too lean or rich on the bottom. It has good scream at top, and good temp, so it's not the high end??
Originally Posted by Brandon Melton
Nah, they were slick before I put them on, lol. Three tanks on the starter box with it set so that at full throttle it just bogs along. After 3 tanks it was WFO, .
Idle, hell it won't even do that now, lol. Have to figure out why.
Schreff- From idle when I gig it full punch, it stalls for split second, then revs and goes. Too lean or rich on the bottom. It has good scream at top, and good temp, so it's not the high end??
Idle, hell it won't even do that now, lol. Have to figure out why.
Schreff- From idle when I gig it full punch, it stalls for split second, then revs and goes. Too lean or rich on the bottom. It has good scream at top, and good temp, so it's not the high end??
The condition you are describing could be either too rich or too lean.
When you go WOT from a dead stop, what does it actually sound like?
If it sounds like someone is choking the motor, then it is too lean.
If it sounds like it is gurgling, then it is too rich.
Either way, you are adjusting the bottom end screw, not the top end.
That's lesson #33. Don't drink while tuning.
Tech Champion
iTrader: (42)
I just saw a UFO..HOLY SH**... Oh wait.. That was a Rod from Brandons motor......
Originally Posted by John Tag
I just saw a UFO..HOLY SH**... Oh wait.. That was a Rod from Brandons motor......
Just wait until after 2 runs with the car when it is covered in dirt and grime. He won't want to clean it.
Originally Posted by schreff
Tags, if he blows that motor up in under a gallon of fuel, he has talent.
Just wait until after 2 runs with the car when it is covered in dirt and grime. He won't want to clean it.
Just wait until after 2 runs with the car when it is covered in dirt and grime. He won't want to clean it.
Tech Champion
iTrader: (42)
More bottom end..Remove vent from pipe to tank and run fuel filter...
Originally Posted by John Tag
More bottom end..Remove vent from pipe to tank and run fuel filter...
The man is not only an electric motor "genius" but he knows how to tune Nitro TOO!!!! WOW I just found new respect for you.
NOT! LOL
Tech Master
iTrader: (34)
Tag, ygpm...actually you got 2 because I hit a wrong button before I was done...oops
What up people, who's racing carpet yet?
What up people, who's racing carpet yet?
Yo X...
What do you mean, who's racing carpet yet?
I think everyone is already. You shoud come up to Horsham for a couple weeks before we all go to Vegas.
Yayaya T minus 14 hours to finally running 4200s.
What do you mean, who's racing carpet yet?
I think everyone is already. You shoud come up to Horsham for a couple weeks before we all go to Vegas.
Yayaya T minus 14 hours to finally running 4200s.
Originally Posted by schreff
Yo X...
What do you mean, who's racing carpet yet?
I think everyone is already. You shoud come up to Horsham for a couple weeks before we all go to Vegas.
Yayaya T minus 14 hours to finally running 4200s.
What do you mean, who's racing carpet yet?
I think everyone is already. You shoud come up to Horsham for a couple weeks before we all go to Vegas.
Yayaya T minus 14 hours to finally running 4200s.
Not everyone.....Tag is trying but we ain't going for it! YET!
Tag you ready for a road trip???? I say we crash "Steaks" place in a few weeks and you can do your rug testing then....
Tech Champion
iTrader: (42)
I'm getting there...ROAD TRIP....
Tech Champion
Carpet starts this weekend for me...Thank God!
Should be a great turnout at Mimi's this weekend. Can't wait!
Tags, you still remember what my order is right? We talked about it a few days ago, just makin sure.
Should be a great turnout at Mimi's this weekend. Can't wait!
Tags, you still remember what my order is right? We talked about it a few days ago, just makin sure.