Our new wire in our 1.1 motors can withstand some pretty gnarly temps.
Question - Are you running boost in modified with an LRP ESC???? If so, WHY??
Tekin Tekin Tekin....All I can say. You can adjust what boost you run, and where it comes in... not just some preset amount of timing with an unspecified and non adjustable amount of delay and ramping rate.
That said: Our 1.1 motors are capable of withstanding 200F heat without issue. We have not been able to short the stators on our 1.1 motors... I have personally melted the solder off of the colloector rings, but that was trying to destroy a motor and was at 338*F. Only problem you may run into, is consecutive runs above 225F can weaken your rotor over time.
If you did not desolder the motor, keep running it, should be fine.
We won Open Wheel last year with our stuff run WITHOUT BOOST on an LRP SXX, without fans.
Keith - In future, email me directly at Dirtoval9@aol.com