Ask Team Tekin
#586
thanks! for the info... i made sure my iron was at its peak and i think it took about 10 or 12 seconds to pull the power wires off...
#587
Tech Rookie
hi there. how can I get my hands on a Tekin FX esc? somewhere on the wideweb preferably, as choices at my LHS's are a bit limited down here at my side of Oz...
cheers, Nils
cheers, Nils
#588
https://www.ssl-stormerhobbies.com/c...s&pn=TEKTT1090
#589
Tech Rookie
great, thanks for the quick reply!
#591
#592
What's the general turn around time for servicing brushless esc? As for the older escs like the brushed ones, does Tekin still service them?
#593
We quote 7-10 business days but the average is less than 5 days here. We still service the FX series and the G11 series brushed ESCs. Anything pre-G11 is a legacy product and we don't offer service them due to lack of available parts.
#594
Tech Adept
Does the Tekin 17.5 run with the castle sidewinder ESC? I installed my new tekin, and seem to have about 1/2 the power I should. Slow as a snail. Checked the esc and transmitter, and all settings are on full. Help!
T
T
#595
nice
Last edited by chucko; 07-10-2011 at 01:48 PM. Reason: already answerd in another thread
#596
It should be fine, do you have any "cheat" in the ESC? Timing? What car do you have it in and where is it geared?
#597
Tech Adept
Stock Gear in the Losi xxx-sct. 16/88. What are your thoughts on what it should be for 2x4. I'm guessing a whole lot bigger on the Pinion. Also, with the Sidewinder, I'm running it sensorless....does that matter?
#598
Try gearing it 24/87ish. Check out Randy's setup: Randy Pike XXXSCT 17.5 v212
#599
I have a redline motor that the mounting screw holes are stripped out, I see Stormer lists a replacement endbell kit but is out of stock. Where can I get this kit; or just the front alum piece that the holes are stripped; from?
Thanks
Chris
Thanks
Chris
#600
Tech Master
iTrader: (21)