Pirvan

Hi Guys, i was just wondering about something.

When i dismantled the clutch and 2 speed on my RS12 and tried to fit it to a CVR, i noticed that the shaft on the CVR was not long enough. Is the longish shaft (is that the 2 speed pilot shaft)on the RS12 removable? And do i have to transfer that shaft onto the CVR to fit the 2 speed? If so, how do i go about doing it?

Thanks

Jeff

hooked_on

iTrader: (1)

Pirvan,

As part of the kit, you get all the conversion parts required to adopt any eninge into the v1r. What you will be looking for is a small shaft to screw onto the crank to adapt it to the correct length.