TheYellowDart

iTrader: (1)

Built and ran my f1 and it was AWESOME! So much more smooth and fast than my touring car, hooked up nicely. The only issue I had was a couple of times the rear end would slide out in a turn, I think I might have been locking up the rear when using brakes?

astgerma52sp

iTrader: (19)

Was it coming loose, getting into a turn, after a long straightaway?

TheYellowDart

iTrader: (1)

Yes exactly that, a long straight into a uturn- maybe I am going in too fast?

shortcut

iTrader: (55)

Yep, sounds like you might have been over braking

Shaun B22

iTrader: (3)

Anyone know if the bitty design bodies fit the 2016 X1?

astgerma52sp

iTrader: (19)

You have too much rear droop. Check to make sure that it is between .5 or less than 1 mm of droop in the rear. That should eliminate the problem. Also make sure your steering throw is equal left to right and you have about 1° of toe out in the front.

TheYellowDart

iTrader: (1)

Thanks for the tips - I am pretty new so I don't have any of the setup stuff to even measure what I have right now. I will run over to the hobby store in the morning to get a droop gauge to see where I am at. I am following this tutorial: http://site.petitrc.com/reglages/xra...dChassisFront/

astgerma52sp

iTrader: (19)

This should also help. https://lookaside.fbsbx.com/file/new...cCBAYYUUELDDMg


To measure droop, you do not need the droop blocks just the ride height gauge.

Customworksking

iTrader: (74)

best body stock v2 ? thanks

nova2015

iTrader: (5)

I'm assuming you're measuring droop at the rear of the pod?

Customworksking

iTrader: (74)

yes

chensleyrc1

iTrader: (38)

Sorry for the late response, went racing and stuff, lol.
I am running a Spektrum version of the same servo. I had a couple of them laying around and used it.

TheYellowDart

iTrader: (1)

I can't get this link to work - Anyone else having problems?

tunerjetta29

iTrader: (6)

Yes they do!

astgerma52sp

iTrader: (19)

Try this one:
http://www.directupload.net/file/d/4...tv39gz_pdf.htm