ernestf

iTrader: (2)

asw7576, thanks for your input.
I will try to increae the pinion size by 1T to 2T next time and time the total run time.

Thanks
Ernest

Frank N. Furter

I run my 9 on 7:1 outdoors - track has a 100ft straight.
Would run an 8 on about 7.25 with GP3700.

asw7576

Damm...... seriously you dare to run checkpoint motor 8T @ 7.25 final gear ratio ? should check the comm often.......... What timing do you dare to use if you pick 7.25 final gear ratio ?

Frank N. Furter

Well it is a bit colder here
Timing would be at the first mark (not a lot in other words).

alan orton

Has anyone got there hands on one of these motors yet, have they been released by Checkpoint ?

NismoSkyline17

They were suppose to be released 2/28. I ordered three for myself at my LHS so I'll find out by the end of the week if they really were released.

alan orton

Comment from the suppliers would be most welcome,is the pre-release hype on these motors justified?

BritRacer

tower has gone from "late feb" to "on order" not sure if this is a forward step or not!

NismoSkyline17

Usually is a step forward.

alan orton

i have a order with tower since early december, i have tried to get a sensible reply to my many e-mails, but keep getting computer generated replys which always end in "Have a nice day"
I might have a VERY nice day if i could get my hands on a Checkpoint 19 turn motor "Mr Tower"

Monti

iTrader: (44)

Wait till everyone sees the new Motor label for the 19t it is so awsome. I think it is the best motor label ever! Oh yeah, I am sure the motor it's self should be good too!

Hey Dizzle how about a pic?

-Monti-

NismoSkyline17

There's a picture of it on Tower Hobbies website.

rc-zombies

iTrader: (9)

It was Late Feb..
Tower's now saying... Late March arrival..

G-Dizzle

Money

G-Dizzle

Monti P-
Did you see the updated news on the site?
George