theatriks

iTrader: (8)

Hey guys quick question i got a spec r gear diff for my xray t3 2012 and when i put the too cases together it doenst fit flush theres about 1mm to 1mm and a half of a gap and im test fitting it without the gears in ti so its not a jamming issue .....is this common from this company ...i could just sand the case down and get it to fit but i shouldnt have to do this....does spec r take care of there customers if they send out a defective product?

Mike Mandio

iTrader: (5)

I purchased a gear diff that had the wrong outdrives included in the package. A couple of emails back and forth and the problem was solved. I was very pleased with their customer service.

Hyde

iTrader: (1)

Contact them and request another one.

poochy

iTrader: (11)

over tightening the screws will cause the case to separate

theatriks

iTrader: (8)

The case doesnt fit flush without the screws ....i didnt even try to screw it together....anyways i just sanded it down then screwed it together and its flush now.