bigbadbronx2k12

Pm me with a list and what you want for it.

bigbadbronx2k12

Siccmade, you got a PM dude.

Siccmade

iTrader: (2)

pm responded to and i have heres what i got....I have a barley used yokomo GT4 4wd 2spd that i have maybe only drove a few times. The only thing it needs is 1st and 2nd gear ajusted thats it and it has the starter box with it and a remote and receiver and i think some extra tires.

bigbadbronx2k12

Ok stupid question, should I use pads on the brake plates when using the Penguin carbon fiber rotor. Resurecting my GT4 S (S for Steve Edition lol) and before I run it I had to ask. Yokomo 4 life!

nitrodude

iTrader: (8)

No pads with the carbon disk

bigbadbronx2k12

Thanks dude for verifying. I thought I was right, always good to check though.

bigbadbronx2k12

So does anyone have an accurate list or knowledge of what parts from other cars fit the Yoke?

codeofdastreets

I have a roller gt-4 with most of the parts left that are in the pictures..Cars collecting dust and rather have it in someone elses hands that will use it.. I"ve had my fun with these and now im into going fast in real cars..

http://www.rctech.net/forum/r-c-item...pgraded-2.html

Siccmade

iTrader: (2)

My car is rtr and the thing is almost new, used very little.

Jay7

Has anyone put on a Centax clutch on a Yokomo GT4? Which clutch/flywheel works for this upgrade?

impalabob64

iTrader: (2)

I have the R version forsale comes with centex clutch an also oneway up front, car is superclean has a lola 1/10 body an servos $200.00 shipped.

-R2-

iTrader: (4)

I saw that Nitrohouse had some Yokomo Gt-4 parts in a box in the corner, maybe you can call them about what parts they have.

800-928-0304

HickamHatch

iTrader: (12)

Does anyone have a link to a manual to the RTR? I recently picked one of these up and can't seem to find one anywhere. I have found the manual for the kit and how it gets put together, but nothing for the carb settings. Looks like this thing hasn't been ran in years. Thanks!

YR4Dude

iTrader: (44)

I don't think the RTR had a low end needle but if it does, try this: 1.5 turns low end, 2.5 turns high end. Close the needle valves all the way, then open them by turning it counter clockwise those number of turns.

HickamHatch

iTrader: (12)

I think it only has a high speed needle.