Xray T3 2012
#2871
Hagberg mod
I don't know if any of you have tried this but i milled the rear block down till it was the same width as the mounts in the front . If I. Remember right it was a little over a mm per side. I never liked the fact that they weren't square so I made it symmetrical . Of course this was before I changed to the exotek chassis and blocks which are already narrow compared to the stock xray
#2872
#2874
I don't know if any of you have tried this but i milled the rear block down till it was the same width as the mounts in the front . If I. Remember right it was a little over a mm per side. I never liked the fact that they weren't square so I made it symmetrical . Of course this was before I changed to the exotek chassis and blocks which are already narrow compared to the stock xray
#2875
Hagberg
I understand why it was done but when you wanted to run more rear toe or 1 deg rear hubs you were already at max legal width . Most people ran -.75 rear hexes to Narrow it up. If it would have been narrower this wouldn't have been a issue which it's really not because people find a way to make it work regardless.
#2876
Tech Regular
I understand why it was done but when you wanted to run more rear toe or 1 deg rear hubs you were already at max legal width . Most people ran -.75 rear hexes to Narrow it up. If it would have been narrower this wouldn't have been a issue which it's really not because people find a way to make it work regardless.
#2877
Tech Master
iTrader: (29)
http://hagberg.blogs.se/2012/01/18/r...tion-12479898/
#2878
This mod makes the rear of the car quite a lot narrower which results in more turn-in and mid corner rotation. The car will be more aggressive and difficult to drive but faster for some conditions.
http://hagberg.blogs.se/2012/01/18/r...tion-12479898/
http://hagberg.blogs.se/2012/01/18/r...tion-12479898/
I haven't found a situation where it wasn't better (for me at least) so I haven't taken it off.
Mark, get some spare pivot blocks and try it.
#2879