Norman2

Hi, Attached photos of my entry in the World GT class. It is a Revolution
1/10 on road pan car but converted to 4 cells. Body is Parma Aston Martin DB9 which is approved. Hope you like. Regards
Norman2

303slowdown

iTrader: (24)

That body looks great. Looks like it could race on tv

Mino

iTrader: (3)

thats got to be the coolest body I have ever seen on a on road car, nice!

Scooby Horton1

I race wgt all the time that body works well!

TonyK

iTrader: (5)

Good looking car I wish we had a WGT class where I race.

Hpimichael

hey guys,

this might sound dumb to ask, but does would this body fit on a 200MM nitro car ?( with a hole cut out for the engine) i want a Aston martin body and this is the only one i can find

AreCee

iTrader: (1)

Parma PSE makes the 200mm DB9 body. It works quite well on a WGT as I have been using it for the past two years.

BTW, what body are you talking about, I don't see one.

Hpimichael

http://www3.towerhobbies.com/cgi-bin...?&I=LXXCU7&P=7

this body posted above. in the OP post

but it would work on a nitro car you think?

wingracer

iTrader: (24)

It probably will, I have run the old Protoform Corvette WGT body on a nitro TC before.

FauxMako

Front end might be too low for a TC chassis.

This one's only 190mm, but it might work:

http://www.r2hobbies.com/1-10-aston-...-car-body.html

Serzoni

iTrader: (13)

Kyosho had one, but I think it's discontinued now. Part #39284 for the body and part # 39284-1 for the decal sheet.