Beginner- Issue with pull start
#1
Beginner- Issue with pull start
Hi all,
Im new to the RC car business, well i built my car about 2-3 years ago and have never used it as i never got round to getting the final few replacement parts, i got it going last week after getting the few parts i needed, one of which was a new pull start..
now, the problem is, i think some fuel may have got on the chord as it snapped on me earlier today, i was just wondering, should this happen again, is there a way to clean it off so it doesn't get damaged?
I have a thunder tiger pro-12 engine if that makes a differance (shouldnt imagine it would though)
Regards,
Mike
Im new to the RC car business, well i built my car about 2-3 years ago and have never used it as i never got round to getting the final few replacement parts, i got it going last week after getting the few parts i needed, one of which was a new pull start..
now, the problem is, i think some fuel may have got on the chord as it snapped on me earlier today, i was just wondering, should this happen again, is there a way to clean it off so it doesn't get damaged?
I have a thunder tiger pro-12 engine if that makes a differance (shouldnt imagine it would though)
Regards,
Mike