Durango DEX210 Thread
#4111
Tech Regular
Yeah, check with Marcus, by PM, he may even have the blocks in stock.
He is a cool guy.
He runs the 210 so you may be exposed to a lot of goodies, once he gets going on them. He has his focus on the RC Pro and f1s right now. But he developes and test his stuff very thoroughly....lol.
He is a cool guy.
He runs the 210 so you may be exposed to a lot of goodies, once he gets going on them. He has his focus on the RC Pro and f1s right now. But he developes and test his stuff very thoroughly....lol.
#4112
Those are meant for a yet to be released dust boot specific to the 210. They will not hurt anything if you do run them, but we aren't using them until the dust boots are out. I tried cutting down one of the boots from the 410 but it didn't stay on very well.
#4113
Tech Elite
iTrader: (37)
#4115
dang chizzle you cut tooooo much off the gear cases. you can take a little off the motor plate and not the ball cup. the 10mm ball stud can work its way out so we are using a shock end and a losi 22 tierod with a 22 ballcup/10mm ball stud in the hub. with the shock end you can use a 14mm buttonhead screw = just about bullet proof!
#4116
#4117
Tech Elite
iTrader: (37)
dang chizzle you cut tooooo much off the gear cases. you can take a little off the motor plate and not the ball cup. the 10mm ball stud can work its way out so we are using a shock end and a losi 22 tierod with a 22 ballcup/10mm ball stud in the hub. with the shock end you can use a 14mm buttonhead screw = just about bullet proof!
#4118
Looks like Dayton's old car... bring it down to Leisure Hours and play this weekend!
#4119
#4120
Fever this weekend? We've been wanting to come back up.
On another note, we have a set of MOS big bores coming from Tresrey, though they are going to replace the regular bores on the 410. I'll post up some pics and feedback next week once they are installed. As with all of their parts I am expecting a top notch piece that looks great and performs better
On another note, we have a set of MOS big bores coming from Tresrey, though they are going to replace the regular bores on the 410. I'll post up some pics and feedback next week once they are installed. As with all of their parts I am expecting a top notch piece that looks great and performs better
#4121
#4122
I think you will see parts start showing up, this time of year is notoriously bad for getting parts from China and Taiwan
#4124
Nah, I like to run what i want when i want =]