LSN position on Go .28 3 port
#1
LSN position on Go .28 3 port
Hi chaps. Upon installing my new engine;
http://www.apexmodels.com/media/gbu0...800-M20HSG.jpg
the LSN is at such an angle, that it is completely obscured by the exhaust. Surely this is going to make any kind of tuning extremely difficult to say the least?
PS. Also, there's no idle screw? Unless i'm going crazy
http://www.apexmodels.com/media/gbu0...800-M20HSG.jpg
the LSN is at such an angle, that it is completely obscured by the exhaust. Surely this is going to make any kind of tuning extremely difficult to say the least?
PS. Also, there's no idle screw? Unless i'm going crazy
#3
Is this correct? If so, though it's hard to see from the pic, the exhaust completely blocks the LSN