Ask Chris Tosolini
#661
Chris is its posible to get your 1:12 setup from the snowbirds
Thanks
Thanks
#662
Tech Regular
Originally posted by HappyHippo
Chris is its posible to get your 1:12 setup from the snowbirds
Thanks
Chris is its posible to get your 1:12 setup from the snowbirds
Thanks
#663
Thank you Chris for coming and racing at Salem this w/end. We have a bunch of talent in the NW that never fail to impress me. This event took the whole gig up a couple of notches. Set up is one thing,but driving skill from practice practice practice... phweew ..Blinding.
Them Corally's are a cute bit of jewelry t'boot.
All the best, Jacko
Them Corally's are a cute bit of jewelry t'boot.
All the best, Jacko
#664
hey toso
Hey Toso,
check your PM,
Matt Griffin
check your PM,
Matt Griffin
#666
Tech Rookie
about setting
What 's happen?If front lower arm position is minus (rear positon higher front position).
#667
Tech Champion
iTrader: (62)
Chris, I've been having problems with my diff slipping on the RDX. First time I built the diff it went together fine smooth with no slippage. I ran the car that next weekend with no problems. I disassembled the diff to clean it and re-lube it and now when I rebuild it I can not get it to stop slipping. (I have built many cars in the past and I'm sure it is together as per the instructions...
Any thoughts on the problem???
Any thoughts on the problem???
#668
Tech Regular
Re: about setting
Originally posted by hotman
What 's happen?If front lower arm position is minus (rear positon higher front position).
What 's happen?If front lower arm position is minus (rear positon higher front position).
#669
Tech Regular
Originally posted by The Teacher
Chris, I've been having problems with my diff slipping on the RDX. First time I built the diff it went together fine smooth with no slippage. I ran the car that next weekend with no problems. I disassembled the diff to clean it and re-lube it and now when I rebuild it I can not get it to stop slipping. (I have built many cars in the past and I'm sure it is together as per the instructions...
Any thoughts on the problem???
Chris, I've been having problems with my diff slipping on the RDX. First time I built the diff it went together fine smooth with no slippage. I ran the car that next weekend with no problems. I disassembled the diff to clean it and re-lube it and now when I rebuild it I can not get it to stop slipping. (I have built many cars in the past and I'm sure it is together as per the instructions...
Any thoughts on the problem???